Ultrafast switching of telecom photon-number states

Basic Information

• Paper ID: 2504.12376
• Title: Ultrafast switching of telecom photon-number states
• Authors: Kate L. Fenwick, Frédéric Bouchard, Alicia Sit, Timothy Lee, Andrew H. Proppe, Guillaume Thekkadath, Duncan England, Philip J. Bustard, Jeff S. Lundeen, Benjamin J. Sussman
• Classification: quant-ph physics.optics
• Publication Date: October 14, 2025 (arXiv v2)
• Paper Link: https://arxiv.org/abs/2504.12376

Abstract

This paper demonstrates an ultrafast all-optical switch based on the optical Kerr effect in single-mode fiber, enabling ultrafast switching of heralded photon-number states (up to 6 photons) in the telecom band. High-intensity pump pulses centered at 1030 nm generate localized birefringence in the fiber, temporally overlapping with 1550 nm signal photons. The experiment achieves >99% switching efficiency, 2.3 ps temporal resolution, 2.27±0.08 dB insertion loss, and a signal-to-noise ratio of 32,000.

Research Background and Motivation

Core Problem

The core problem addressed by this research is achieving high-speed, low-loss, and low-noise quantum light state modulation and switching in photonic quantum information processing platforms. Specific challenges include:

1. Scalability Requirements: Scaling quantum photonic systems requires the ability to handle higher photon numbers or larger squeezed states
2. Feed-forward Operation Demands: Measurement-based feed-forward methods require real-time fast switching capabilities
3. Time-Encoding Applications: Ultrafast time-bin encoding (UTBE) requires picosecond-scale operational capabilities

Importance Analysis

1. Quantum Technology Development Bottleneck: Loss remains the primary limiting factor for scaling quantum photonic systems
2. Detector Performance Limitations: Transition-edge sensors (TES) have microsecond response time constraints, necessitating ultrafast switches to circumvent them
3. Coherence Maintenance: At picosecond timescales, environmental fluctuations are effectively frozen, suppressing decoherence induced by mechanical instability

Limitations of Existing Methods

1. Electro-optic Device Constraints: Gigahertz-frequency modulation is conventional, but terahertz (picosecond) ranges can only be achieved through all-optical means
2. Wavelength Band Limitations: Most all-optical switch demonstrations focus on the visible range (~800 nm), with relatively limited exploration in the telecom band (1550 nm)
3. Efficiency-Loss Trade-off: Achieving high-efficiency ultrafast switching of single photons with low loss in the telecom band remains an open challenge

Core Contributions

1. Achieved ultrafast all-optical switching of heralded photon-number states in the telecom band: First demonstration of picosecond-level switching of 1-6 photon-number states at 1550 nm
2. Attained >99% switching efficiency: Achieved near-perfect switching performance with 8 nJ pump pulse energy
3. Realized 2.3 ps temporal resolution: Corresponding to ~434 GHz bandwidth, comparable to state-of-the-art electro-optic modulators
4. Achieved extremely low noise levels: Signal-to-noise ratio of 32,000, with noise counts approximately 1×10⁻⁵ per pulse
5. Established comprehensive theoretical model: Simulation model based on split-step Fourier method accurately predicting switching behavior

Methodology Details

Task Definition

The task of this research is to design and implement an all-optical switch capable of ultrafast switching of heralded photon-number states in the telecom band. The input consists of 1550 nm heralded photon-number states, with output being switched/unswitched photon states controlled by 1030 nm pump pulses.

System Architecture

Light Source System

• Master Laser: Commercial ytterbium-doped ultrafast laser system (Carbide, LightConversion)
  • Pulse width: 180 fs
  • Center wavelength: 1030 nm
  • Repetition rate: 200 kHz
• Optical Parametric Amplifier: Tuned to 775 nm, pumping ppKTP crystal to generate 1550 nm degenerate photon pairs

Switching Mechanism

Based on cross-phase modulation (XPM) in 24 cm single-mode fiber (SMF):

Switching Efficiency Formula: $\eta = \sin^2(2\theta) \sin^2\left(\frac{\Delta\phi}{2}\right)$

Where:

• $\theta$: Polarization angle between signal and pump light
• $\Delta\phi = \frac{8\pi n_2 L_{eff} I_p}{3\lambda_{signal}}$: Nonlinear phase shift induced by pump
• $n_2$: Nonlinear refractive index of SMF
• $L_{eff}$: Effective length of nonlinear medium
• $I_p$: Pump pulse intensity

Detection System

• SNSPD Mode: Low average photon number ($\langle n\rangle = 0.24 \pm 0.02$), utilizing ~20 ps low-jitter timing for photon-number resolution
• TES Mode: High average photon number ($\langle n\rangle = 3.86 \pm 0.05$), providing intrinsic photon-number resolution capability

Technical Innovations

1. Group Velocity Mismatch Utilization: The group velocity difference between pump and signal photons extends the interaction time to ~2 ps, facilitating uniform switching of signal photon wavepackets
2. Polarization Control Strategy: Precise setting of pump pulse polarization to maximize signal photon polarization rotation
3. Split-Step Fourier Simulation Model: Comprehensive model considering self-phase modulation (SPM) and group velocity dispersion (GVD) effects
4. Dual-Detector Architecture: Combining advantages of SNSPD and TES, optimizing measurements for single-photon and multi-photon-number states respectively

Experimental Setup

Experimental Parameters

• SMF Length: 24 cm (1060XP, Thorlabs)
• Pump Wavelength: 1030 nm
• Signal Wavelength: 1550 nm
• System Repetition Rate: 200 kHz
• Correlation Window: 60 ps (SNSPD mode), 1 μs (TES mode)

Evaluation Metrics

1. Switching Efficiency: $\eta_{exp} = N_{S,i}/(N_{U,i} + N_{S,i})$
2. Insertion Loss: Including all relevant optical components for achieving near-perfect switching
3. Temporal Resolution: Time width at 10 dB full width
4. Signal-to-Noise Ratio: Calculated based on heralding detection probability and noise counts

Comparative Verification

• Qualitative comparison between experimental measurements and split-step Fourier simulations
• Performance characterization under different pump energies and delay conditions
• Spectral fidelity verification

Experimental Results

Main Performance Metrics

Switching Efficiency Analysis

• Energy Dependence: Exhibits quadratic sinusoidal variation with increasing pump pulse energy
• Optimal Operating Point: Achieves >99% efficiency at 8 nJ pump energy
• Temporal Stability: Maintains >98% efficiency within ~533 fs range

Photon-Number State Switching Results

For heralded N-photon states (N=1-6), the experiment measured probability distributions $P_{n_S,n_U}$:

Noise Characteristics

• Pump Noise: Approximately 1×10⁻⁵ noise counts per pulse
• Comparative Advantage: One order of magnitude lower than visible-range demonstrations
• Noise Sources: Primarily attributed to other nonlinear processes induced by the pump within the switch

Related Work

Major Research Directions

1. Electro-optic Modulators: Conventional methods achieving >100 GHz bandwidth, limited by electronics
2. All-optical Switches: Primarily concentrated in visible wavelength range (~800 nm), with relatively limited exploration in telecom band
3. Quantum Photon Detection: SNSPD and TES photon-number resolution capabilities at different timescales

Advantages of This Work

1. Wavelength Band Advantage: Focuses on the telecom band with minimal fiber transmission loss
2. Efficiency Breakthrough: Achieves high efficiency in single-photon ultrafast switching in the telecom band
3. Multi-photon Capability: First demonstration of ultrafast switching of heralded photon-number states

Conclusions and Discussion

Main Conclusions

1. Successfully demonstrated ultrafast switching of photon-number states in the telecom band based on optical Kerr effect in SMF
2. Achieved near-perfect switching efficiency combined with reasonable insertion loss and extremely low noise
3. Verified the practicality of this method in ultrafast quantum photonic applications

Limitations

1. Insertion Loss: 2.27 dB loss primarily limited by fiber coupling; free-space setup increases complexity
2. TES Detection Window: 1 μs long detection time window introduces additional noise, causing slight efficiency reduction
3. Fiber Length Constraint: 24 cm short fiber length limits optimization space for nonlinear interaction

Future Directions

1. Loss Optimization: Further reduce insertion loss through lower-loss optical components and automated SMF coupling
2. Medium Exploration: Investigate alternative fiber geometries or nonlinear media for better control of spectral and temporal characteristics
3. All-Fiber Implementation: Develop all-fiber versions to minimize dispersion and achieve faster switching times
4. Integrated Applications: Integration with superconducting detectors to realize high-speed, low-loss quantum information processing systems

In-Depth Evaluation

Strengths

1. Technical Breakthrough: First high-efficiency ultrafast switching of heralded photon-number states in the telecom band
2. Experimental Completeness: Comprehensive verification from single-photon to 6-photon states with excellent agreement between theory and experiment
3. Practical Value: Provides critical technology components for scalable quantum photonic systems
4. Methodological Innovation: Clever utilization of group velocity mismatch for uniform switching with well-designed approach

Weaknesses

1. System Complexity: Free-space setup increases system complexity and potential instability
2. Insufficient Loss Analysis: Limited detailed analysis of insertion loss sources and optimization strategies
3. Long-term Stability: Lacks assessment of long-term operational stability and environmental sensitivity

Impact

1. Field Advancement: Establishes important foundation for ultrafast quantum photonics development in the telecom band
2. Application Potential: Directly supports practical applications in quantum communication, computing, and metrology
3. Technical Benchmark: Establishes performance benchmarks for telecom-band ultrafast optical switches

Applicable Scenarios

1. Quantum Networks: Long-distance quantum communication systems in the telecom band
2. Quantum Computing: Photonic quantum computing platforms requiring fast feed-forward operations
3. Precision Measurement: Quantum-enhanced sensing and metrology based on photon-number states
4. Time Encoding: Quantum information processing with ultrafast time-bin encoding

References

This paper cites 34 relevant references spanning multiple fields including quantum optics, nonlinear optics, ultrafast photonics, and quantum information processing, providing solid theoretical and experimental foundations for the research.

Overall Assessment: This is a high-quality experimental physics paper achieving significant breakthroughs in ultrafast quantum photonics in the telecom band. The experimental design is ingenious, results are convincing, and it provides important technical foundations for future quantum photonic technology development.